Bootsausstattung Kähne – Bootsausstattungen und Textilien

SANDORA wall and ceiling paneling in the cabin

SANDORA – wall and ceiling cladding in suede look

SANDORA is a resistant wall and ceiling textile. Thanks to its elasticity, the boat wallpaper SANDORA makes it easier to work in hard-to-reach places in cabins and interiors of boats, yachts, caravans and mobile homes. The charmeuse on the back of the wall and ceiling cladding increases the strength, conceals minor unevenness and serves as a non-slip surface for the adhesive. Charmeuse is a tight knit fabric made from synthetic fibers. SANDORA is easy to work with, it is cut edge resistant and has a slightly insulating effect in hot or cold conditions.
We recommend our solvent-free UNI-Glue 140 for gluing.
You can create templates in advance for areas that are difficult to access. Our stencil film is ideally suited for this.

When processing the wall and ceiling cladding directly on the boat wall (e.g. GRP) it can be exposed to strong sunlight come to light through. This is not a defect, but is explained by the composition and construction of the hull.

Properties

• Elastic
• Slightly heat and cold insulating
• Lightfast: Grade 5-6
• Abrasion-resistant: 30.000 tours
• Cut edge resistant

Dimensions

• Total thickness: approx. 4 mm
• Width: approx. 140 cm, 7005 gold approx. 160 cm
• Delivery: from 1 running meter
• Rolll length: approx. 30 m

Areas of application

Boat, yacht and shipbuilding, home, caravan and vehicle equipment.

Composition

• Upper material 100% polyester
• Foam and charmeuse made of polyamide
• Total weight / m² approx. 440 g

Cleaning

Wipe with a damp microfiber cloth. Stains must be treated beforehand with mild detergent or upholstery foam.

SANDORA with rear view

Processing

Cut SANDORA wall and ceiling textile generously to size according to the area. Then apply the solvent-free UNI-Glue 140, about 2-3 cm back from the edges, to the surfaces to be glued in stages. Allow the adhesive to flash off a little – observe the data sheet (supplied). After a given time, place SANDORA in the still semi-damp adhesive bed, also in stages, correct it if necessary and then press firmly. Cut the edges, apply a little glue, let this also briefly flash off, glue on the mounting rails and insert SANDORA.

Our samples are color samples from our sample store, the color of which may differ slightly from the stock goods.